Alaris® IMED PC-1 Infusion Pumps

Save Up to 80% on Alaris® IMED PC-1 Infusion Pumps

Buy or rent pre-owned, recertified Alaris® IMED PC-1 Infusion Pumps you need today. All pre-owned medical equipment is patient ready equipment and is covered by an OEM matched warranty.

Specifications

Dimensions:
10.8” x 8.2” x 6.5”

Weight:
11.3 lbs

Operating Principle:
Linear Peristalsis

Power Requirements:
90-130 (120 nominal) VAC, 0.5A, 50/60 Hz, 3 wire, single phase

Electrical Leakage:
Less than 100 microamps

Rate Selections:
0.1-999 mL/hr
MICRO 0.1-99.9 mL/hr (in 0.1 mL/h increments)
MACRO 1-999 mL/hr (in 1 mL/h increments)

Volume to be Infused Selections:
0.1-9999 mL, ALL
MICRO 0.1-999.9 mL (in 0.1 mL increments)
MACRO 1-9999 mL (in 1 mL increments)

KVO Rate:
1 mL/hr if set rate is 1 mL/hr or above, or actual rate if set at 0.9 mL/hr or below

Occlusion Pressure:
Controller Mode: Container height
Pump Mode: 10 + 2 psi for rates above 30 mL hr. For rates of 30 mL/hr and below, the occlusion pressure will be less than 10 psi, and is rate dependent, unless locked into 10 psi for all rates.

Air in Line Detection:
Ultrasonic

Secondary:
Dual rate programmable

RS-232-C Communications Data Port Connector:
Electronic Industry Association (EIA) Standards require standard 9-pin sub-miniature male mating connector with a standard screwlock backshell with jack screws for proper mechanical interface.