LifeCare PCA™ Syringe Infusion Pumps

Specifications

Pump Line:
Hospira LifeCare PCA™ Syringes

Pump Type:
Pain Management

Dimensions:
Approximately 8″W 13″H 6″D, excluding pole clamp protrusion and power cord storage

Weight:
Approximately 10 lbs. with battery

Battery Life:
A fully charged conditioned battery shall provide at least 3 hours of continuous operation from the
start of delivery at 5 mL/hr to Dead Battery

Power Requirements:
105-130 Volts, 57 – 63 Hz,

Recharge Time:
After discharge to the LOW BATTERY operative limit, the battery will recharge to at least 80% of its charge capacity in 16 hours, provided it is plugged into rated AC power. The infuser will operate on AC power in the event the battery is open or shorted

Delivery Rate Accuracy:
± 5% at continuous delivery rates greater than 1 mL/hr

Delivery Rates:
Delivery rate parameters vary depending on mode chosen, drug and concentration selected. Refer to the System Operating Manual for specific details

PCA Mode:
Approximately 1 mL in 35 seconds

Continuous Mode:
Variable from 0.1 x concentration (mg/hr or mcg/hr) to 20 x concentration (mg/hr or mcg/hr)
PCA + Continuous Mode: Variable from 0.1 x concentration (mg/hr or mcg/hr) to 20 x concentration (mg/hr or mcg/hr), + PCA dose (mg)

System Alarms:
Empty Syringe, Door Open, Infuser Paused, Low Battery, Dead Battery, Bar Code Not Read, Check Settings, Occlusion, Check Syringe, Check Vial, Check Injector, Pendant Fault, Decimal Point Not Allowed, Check PCA Infuser Set to Relieve Pressure, Malfunction

Occlusion Alarm Pressure:
15 psig ± 5 psig

Lockout Interval Range:
5 to 120 minutes in 1-minute increments

Maximum Infusion Pressure:
45 psig